![]() Your wall receptacles are supposed to be wired so that the smaller slot is hot and the larger slot is neutral. Is the plug you have selected polarized, that is, does it have one blade larger than the other so it will only go into the receptacle one way? If not, get one that is polarized. The switch is supposed to be in the hot wire. This varies in current capacity depending on its size and number of strands between 3.5 A to 7 A or maybe 10 A if the cord is larger than it appears in the picture. Your proposed wiring is stranded wire "lamp cord" to wire this motor. What is the current draw of this motor? You should select the power cord based on the current draw of the motor. How do you propose to enclose the motor and protect the connection of the cord to the leads of the motor? You can buy cords with the switch already in. You would be better off an inline switch designed for flexible cord. The flap could cut the insulation on the cord. The box has flaps covering openings for heavy #14 or #12 sheathed cables to enter and be clamped. The electrical box you have chosen is designed to be inside a wall, not loose on a table or on the floor. ![]() Something in the documentation accompanying the motor or written on the motor will probably tell you which this is. It may be that the motor is designed to have either lead be hot or it may be that one particular lead is supposed to be the hot. One of the leads will definitely be connected to neutral and one will definitely be connected to hot. Do not assume that the fact that both leads from the motor are black means that the motor "has no neutral". ![]()
0 Comments
Leave a Reply. |